Water leakage or overflow in a toilet is one of the biggest household problems where gallons of water get wasted. Due to persistent use, there might be one or a couple of factors responsible for creating a messy situation in the bathroom.
Have a look at some of the tips that might be of substantial help on how to fix a running toilet:
1. Check the tank first
Checking inside the tank is the first step to notice leakage inside. If you flush, you would be able to locate the area inside the tank that has a problem.
2. Check the waterline
Insufficient water supply in the tank can allow the toilet to run. Check the waterline to see if the tank has filled in properly or not. If it is not filled properly, check the flapper.
3. Check the flapper
The flapper is the most common reason for a running toilet. Sometimes, the chain gets entangled under the flapper while using the handle. This stops the even flow of water into the bowl. So by simply adjusting the flapper position can help solve the problem.
4. Replace the flapper
If the flapper is old and used quite often, think about replacing it soon. Sometimes it becomes extremely stiff preventing auto-closure.
5. Check or replace the float
The float stops the overflow of liquid and stays above the surface when the tank is refilled. In case it doesn’t stay at that position, it should be replaced soon. A worn-out or damaged float allows water to overflow from the tank. Place the float in carefully. The arm should be bent to allow it to stay above water.
6. Remove mineral build up
Sometimes water starts leaking into the bowl due to mineral build up in and around the flapper or valve. Using a bleach solution or abrasive paper on the affected area can help clean the entire component and fix a running toilet.
7. Replace the rubber seals
Components like the flush valve and flapper valve use rubber seals. Sometimes the rubber gets broken and falls apart leading to leakage. Replace them and check their quality after every month or two to see if they are fit for the purpose or not.
8. Check water pressure
At times, the flapper valve doesn’t sit in the appropriate position in the tank due to water pressure. If the pressure level between the rubber fill tube and overflow tube is higher compared to normal levels, try to partially close the shutoff valve on the wall.
9. Replace small non-rubber components
Non-rubber, metal components might break or fall apart after persistent use. For instance, the lever connected to the float can break, escalating the level of water in the tank. Try to get a new one from the hardware store and replace it as soon as possible.
10. Keep a check every fortnight
If the toilet shows signs of water leakage or overflows frequently, make sure you check all the components and sub-components regularly to detect problems before they occur again. Check the rubber seal, mineral build up and small metal components too.
While at home, it is easy to learn how to fix a running toilet. All the components are available in your local hardware store. If the problem is not resolved on your end, contact a plumber and get it repaired soon.
[Image Source: Wikipedia]